Canceling The Security Function Using A Memory Stick - Eclipse CD7000 Owner's Manual

A security code is entered by
3
pressing the buttons [1] to [4].
Enter a four-digit security code using
digits 0 to 9, A to F.
4
Press the [SCREEN] button.
If a security code is entered and the
main unit verifies that it is correct,
[CANCEL] will appear on the display
and the security function will be
canceled.
ATTENTION
If the security code that is entered does not
match the code that is recorded by the main
unit, [ERR] will appear on the display for two
seconds and operation will continue as normal
without the security function being canceled.
Canceling the security function
using a Memory Stick
Check that the main unit is in
1
standby.
Press and hold button [1], then the
2
[SCREEN] button, and hold both
for more than one second.
A [SEC] message appears, then in two
seconds it will change to [- - - -]
(Security code input display).
3
Press the [MODE] button.
A [MS] message will appear.
ESN security operating procedure
ATTENTION
If a Memory Stick has already been inserted, a
[MS EJECT] message appears. In this case,
eject the Memory Stick and insert again. (Refer
to "Ejecting Memory Stick" on page 36 for
details on ejection of the Memory Stick.)
Insert the Memory Stick and close
4
the front panel.
The recorded data will be read from
the Memory Stick.
If the contents recorded in the
5
Memory Stick
information recorded by the main
unit, [CANCEL] will appear on the
display.
The security function will be canceled
and the main unit will return to normal
operation.
ATTENTION
• If a reading error occurs or if an incorrect
Memory Stick is inserted, [ERR] will appear
on the display for two seconds, and then
the display will change to [EJECT]. If this
happends, eject the Memory Stick and try
again.
• Security setting cannot be canceled by this
procedure if the Memory Stick containing
the security code is formatted.
6
Eject the Memory Stick.
Refer to "Ejecting Memory Stick" on
page 36.
match the
VIII
47