Esn Security Operating Procedure; About Esn; How To Switch The Security Type (Key Cd Security/Memory Stick Security); How To Operate The Esn (Key Cd) Security - Eclipse CD7000 Owner's Manual

ESN security operating procedure

About ESN

This main unit is equipped with ESN (ECLIPSE
Security Network). A preregistered music CD
(Key CD), four-digit security code, or a Memory
Stick on which all main unit functions will not
operate, even by turning the ignition switch to the
ACC or ON position or reconnecting the battery
after turning the
disconnecting the battery during maintenance.
ESN can be set or cancelled using any of the
following methods:
• Key CD security (See page 43)
You can record a specific CD that you have as a
"key CD" with the main unit, and this CD can then
be used to set and cancel the security settings.
• Memory Stick security (See page 46)
You can record a Memory Stick and a secret
code (security code) with the main unit, and this
Memory Stick or secret code (security code) can
then be matched with the main unit to set and
cancel the security settings.
• ACC security (See page 49)
This method can only be used when Memory
Stick security has already been set. When ACC
security is set, button operations are disabled
when the ignition switch is turned to OFF and
then back to ACC.
How to switch the security type
(Key CD security/Memory Stick
security)
You can switch the type of security being used
(Key CD security or Memory Stick security). The
initial setting is for Key CD security to be used.
Check that the main unit is in
1
standby.
ignition switch off

ESN security operating procedure

Press and hold the button [3] , then
2
[SCREEN] button, and hold both
for the more than two seconds.
Security type will switch from Key CD
security (DISC SEC) l Memory Stick
security (MS SEC) in order each time
the button is pressed.
or
ATTENTION
If a security is activated, switching the security
type is not available.
How to operate the ESN (Key
CD) security

How to program the Key CD

Check that the main unit is in
1
standby.
Press and hold the button [6], then
2
[SCREEN] button, and hold both
for more than one second.
A [SEC] message appears, in two
seconds it will change to [DISC].
ATTENTION
• If a CD has already been inserted, a [SEC]
message appears, and then the front panel
opens and the CD is ejected.
• If a security is activated, programming the
Key CD is not available.
Press the
3
button.
The front panel opens; The CD7000 is
now ready for your Key CD in the CD
slot.
[ (OPEN/EJECT)]
VII
VIII
43