Installing The Usb Driver - UNI-T UTD4000 Operating Manual

Uni-Trend Technology (Chengdu) Ltd

1.4 Installing the USB driver

If you are using the oscilloscope's USB device port for software communication and control, the USB
driver must be installed after installation of the oscilloscope communication and control software is
complete. Follow the steps below :
1. There is a USB device port on the rear panel of your UTD4000 Series Digital Storage Oscilloscope.
With the supplied USB A-B cable, you can connect the USB device port to the USB Host port of the
computer and obtain power supply for the oscilloscope.
2. After checking that connection and power supply are normal, power on the digital storage
oscilloscope. When the operation status screen appears, a prompt will appear at the right bottom
corner to indicate "New hardware DSO detected", as shown in Fig 1-10.
Next, an icon will be created for the "New hardware DSO detected", as shown in Fig 1-11.
Then a "hardware update wizard" dialog box will pop up on the desktop, as shown in Fig 1-12.
UTD4000 Digital storage oscilloscope communication control software Operating Manual and Installation Guide
Fig 1-10
Fig 1-11
Fig 1-12
Page 9 of 27