Installation Of The Oscilloscope Communication And Control Software; Hardware Requirements; Installing The Software - UNI-T UTD4000 Operating Manual

Uni-Trend Technology (Chengdu) Ltd
Chapter 1

1.1 Hardware requirements

Equipment requirements Minimal.
Oscilloscope
Computer
Connection cable

1.2 Installing the software

Your UTD4000 Series Digital Storage Oscilloscope ("Oscilloscope") comes with an oscilloscope
communication and control software (contained in the CD-Rom supplied with your oscilloscope)
File name : UTD4000 Digital storage oscilloscope communication control software Operating
Manual and Installation Guide.
Installation :
Step one : Insert the CD-ROM supplied with your oscilloscope into the CD-Rom drive of the
computer. Wait for the system to read and find the oscilloscope communication and control software
contents (Fig. 1-1).
Note : 1. The installation pack downloaded online must be unzipped before application.
2. The software supports Windows 2000, Windows XP and Vista operating systems. On
Vista only USB2.0 communication protocol is supported.
Step two : Double left click the mouse to run the oscilloscope communication and control
software installation as shown in Fig 1-1.
The installation wizard for the oscilloscope communication and control software will
pop up, as shown in Fig. 1-2.
UTD4000 Digital storage oscilloscope communication control software Operating Manual and Installation Guide
Installation of the oscilloscope communication and
control software
UTD4000 Digital Storage Oscilloscope.
Windows 2000/XP/Vista, 128 MB RAM, 16x CD-ROM or better (Vista
users please refer to its individual hardware requirements), SVGA display
or better.
USB A-B connection cable
Page 4 of 27
Fig 1-1