Table of Contents
Advertisement
Uni-Trend Technology (Chengdu) Ltd
Chapter 3 Operation guide for the oscilloscope communication
By now you should have grasped the basic structure, menu options and functions of the oscilloscope
communication and control software. In the following pages you will find more detailed instructions on
how to operate the software. In this chapter, we will give guidance on
To enjoy optimal software performance, we recommend you to read the oscilloscope operating manual and
this chapter to familiar with application.
After installing the software and driver properly, connect the cable to the USB A-B communication port.
Power on the oscilloscope and activate the software. The software control panel shown in Fig 3-1 will
appear on your computer screen.
3.1 USB interface controls
After installing your communication and control software, please install the driver before using the USB
communication mode for the first time. For instructions please refer to "Chapter 1.4 : Installing the USB
driver". When installation is complete, run the software and enter the screen shown in Fig 3-1.
After selecting USB in the equipment selection option, operate as follows :
1.
Select "USB" in the equipment selection option on the virtual control panel.
2.
Click the [Equipment ON/OFF] button to turn it "ON". The indicator light is green. When the
UTD4000 Digital storage oscilloscope communication control software Operating Manual and Installation Guide
and control software
Fig 3-1
Page 21 of 27
control mode.
Advertisement
Table of Contents
