Triumph Daytona 675 Owner's Handbook Manual page 72

Maintenance and Adjustment
Oil and Oil Filter Change
1 Oil drain plug
2 Oil filter
The engine oil and filter must be
replaced in accordance
scheduled
requirements.
engine oil can lead to skin dryn
irritation and dermatitis.
addition, used engine oil contai
harmful contamination that can
lead t o skin cancer. Always wear
suitable protective clothing and
avoid skin contact with used oil.
Warm up the engine thoroughly, and
then stop the engine and secure the
motorcycle in an upright position on
level ground.
Remove the lower fairing.
Place an oil drain pan beneath the
engine.
Remove the oil drain plug.
tc. Contact with hot oil may caus
Unscrew and remove the oil filter
using
an environmentally friendly way.
Apply a thin smear of clean engine
oil t o the sealing ring of the new oil
with filter. Fit the oil filter and tighten to
7.3 Ibf ft (10 Nm).
maintenance
Refit the oil drain plug and tighten t o
18.4
Fill the engine with a 10W/40 or
motorcycle engine oil that meets
specification API SH (or higher) AND
JASO MA.
Start the engine and allow it to idle.
Raising the engine speed above
idle,
parts of the engine can cause
engine damage or seizure. Only
raise engine speed after running
the engine for a few seconds t o
allow the oil to circulate fully.
Triumph service
Ibf ft (25 Nrn).
semi o r fully
before the oil reaches all
tool
synthetic