Alarm And Security Features - Directed Electronics AutoCommand 28624TN Owner's Installation Manual

Alarm and Security Features

Transmitter Arming of the Alarm
You can arm the system by pressing the
mitter for one second. When the system arms, the Horn/Siren
output will chirp once and the parking lights will flash once.
If the power door locks are controlled by the system, the doors will
also lock. While the system is armed, the status LED will flash once
per second, indicating that the system is actively protecting your
vehicle.
If the Horn/Siren pulses and the lights flash 3 times, refer to the
Diagnostics Section. This indicates an alarm input is active at the
time of arming and should be checked. The LED will flash in groups
to indicate the active input.
Passive Arming of the Alarm
This system can be programmed to arm itself automatically (called
passive arming). If the system is programmed for passive arming,
it will automatically arm 30 seconds after the ignition is turned
off and the system detects that you have left the vehicle by
opening and closing a door.
Whenever the system is in its 30-second passive arming count-
down, the status LED will flash rapidly. At the 30-second point,
the Horn/Siren will chirp and the parking lights will flash to indi-
cate that the system is armed.
note! If the door, brake or hood inputs are acti-
vated during the 30 second countdown the
timer will stop and reset, it will re-start once
the input becomes inactive. Active sensor
inputs will not stop the countdown.
66
button of your trans-
© 2006 Directed Electronics