Table of Contents
Advertisement
The user can press the
or
button to stop the alarm (unless TWO-STAGE Mode has been
programmed – one press then only mutes the siren; the user needs to press twice in order to
disarm the system).
Remote Starter Features
Remote Door Locks
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To UNLOCK your doors and DISARM the system:
1.
Press and hold the
button for approx. 1 sec
2.
The
icon will appear on the remote's LCD screen
3.
The siren will chirp twice to confirm that the doors have been unlocked, the Starter Kill
feature is disarmed (if it was installed) and that the Alarm is disabled.
To LOCK your doors and ARM the system:
1.
Press and hold the
button for approx. 1 sec.
2.
The
icon will appear on the remote's LCD screen
3.
The siren will chirp once to confirm that the doors have been locked, the Starter Kill
feature is enabled (if it was installed) and that the Alarm is armed.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button until the remote displays the text "TRUNK" on the screen. In addition, this
will also disarm the alarm.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
Activating Idle mode (Automatic transmission):
1.
With the engine running, make sure to release the brake pedal and press the
button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Idle mode.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle. All doors, the hood and trunk should be closed
4.
Press the
button to lock the doors, to arm the starter kill and to arm the alarm (if
available). The engine will continue running.
a.
When re-entering the vehicle, the user must reinsert the key into the ignition and
turn it to the ON position (not Crank) without pressing on the brake.
b.
Once the key is in the ON position, press on the brake pedal to put the
transmission in gear. Pressing the brake pedal at this step will cancel the remote
starter takeover.
c.
Drive off.
P.12
,
or
User Guide
Advertisement
Table of Contents
