Directed Electronics AutoCommand 25523T Instruction Manual

Remote Control Car Starter Model 25523T Installation Manual
Congratulations on your purchase of the AutoCommand
to start the car by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand ® Professional Series is for automatic transmission/fuel injected vehicles only. It is an extremely sophisticated system with multiple built-in safety and
security features.
• Will start your car by remote control, and run the heater, defroster, or
air conditioner to warm up or cool down the car from up to 1,000 feet
away.
• Is quality engineered, microprocessor controlled, and made in the
USA to provide many years of reliable use.
• Is designed to start the car only if it is in park, and only if the hood is
closed.
• Will attempt to start the car for up to six seconds, but no longer (to
avoid damage to the starter motor). Should the car not start, or if it
stalls after starting, the remote starter will make two further attempts
to start it.
• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes (programmable)
if you forget to come out to your car.
Tools required to install the AutoCommand
Wire Cutters/Strippers
Soldering Iron
Pliers
Test meter
We highly recommend that all connections be soldered for reliability.
Parts List included with the AutoCommand
Remote Starter
Receiver Module
Antenna
Control Harness
(10 position)
The following parts are included in the plastic bag:
Alcohol Pad
Alchohol
Pad
Green 30 A Fuse
On/Off Control Switch
Warning Label
2 Protected by
DesignTech Labels
© 2005 Directed Electronics, Inc.
www.designtech-intl.com • www.directed.com • 800-876-0800
PLEASE READ COMPLETELY BEFORE BEGINNING
® Professional Series Remote Car Starter. The AutoCommand
AutoCommand ® Professional Series Car Starter:
® Professional Unit:
Electrical Tape
Screwdriver
Drill with1/4"and 5/16"
drill bits
® Professional Unit:
Transmitters
6 Power and Ignition wires
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Yellow Butt Connector
P
ROFESSIONAL
® Professional Series Remote Car Starter system allows you
• Will shut off if the brake pedal is pushed, the hood is opened, or the
transmission is shifted out of park - unless the key is in the ignition
and in the "run" position.
• Allows you to remove the key while leaving the car running with the
doors locked for up to 10 or 15 minutes utilizing the Quick Stop™
Option. (See Separate User Tip Sheet)
• Starts the car automatically whenever the temperature drops below
0 ° F(-18 ° C), or if the battery voltage drops below 11 volts when the
Cold Start™ Option is used. (See Separate User Tip Sheet)
• Has the "Daily Start™" feature which allows the vehicle to be started
at the same time the following day. (See Separate User Tip Sheet)
• Comes with a Limited Lifetime Warranty.
Wiring Diagram
Power Harness
Color
Pink
White
Yellow
Blue
Green
Black
In-Gear Switch (inside case)
ON/OFF Switch Jack
Control Harness
Color Function Circuit Type
White/Black Ignition #3 (–) 400 mA
Brown/White Alarm Disarm (–) 400 mA
Brown Accessory (–) 400 mA
Blue Horn (–) 400 mA
Yellow Lights (+) Relay Output No
White - Option
Red LED Light
Red - Code Learn
Color Function Circuit Type
Orange Brake (+) Input
Purple Hood Switch (–) Input
Green Tach (–) Input
Red/White Remote Input (–) Input
Red/Black Diesel (+/–) Input
* For free vehicle specific wire information consult our
websites at www.designtech-intl.com or www.directed.com
S
ERIES
Circuit
Function Type Required
Power (+12V) Input Yes
Accessory Relay output Yes
Starter Relay output Yes
Ignition 1 Relay output Yes
Ignition 2 Relay output Consult Wiring Guide*
Ground Input Yes
Required
Consult Wiring Guide*
Consult Wiring Guide*
No
No
Required
Yes
Yes
No
No
No
Coax
Antenna
Jack
v5.3 25523