Directed Electronics Ready Remote 23927 Instruction Manual

Congratulations on your purchase of the Ready Remote Car Starter. The Ready Remote Car Starter allows you to start your car by remote control from
the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
Ready Remote is for automatic transmission/fuel injected gasoline vehicles only. Please see pages 6 and 7 for important information on factory anti-theft
systems. Ready Remote is an extremely sophisticated system with multiple built-in safety and security features.
• Will start your car by remote control from up to 1,000 feet
away, and run the heater, defroster, or air conditioner to
warm up or cool down the car.
• Is designed to start the car if it is in park, and only if the hood is
closed.
• Lets you lock and unlock doors and pop the trunk by remote.
• Will attempt to start the car for up to six seconds, but no longer (to
avoid damage to the starter motor). Should the car not start, or if
it stalls after starting, the remote starter will make two further
attempts to start it.
• Protects your vehicle with a basic alarm system.
• Requires the user to "enable" the unit to prevent accidental starts.
Tools Required to Install the Ready Remote System:
Wire Cutters/Strippers
Soldering Iron
Pliers
Testmeter
We highly recommend that all connections be soldered for reliability.
Parts Included with the Ready Remote System:
Remote Starter Receiver Module
Transmitter
Antenna
Control Harness (10 position)
6 Power & Ignition wires
The following parts are included in the plastic bag:
Alchohol
Alcohol Pad
Pad
Green 30 A Fuse
On/Off Control Switch
WARNING
Warning Label
This car is equipped with a remote control starting device.
Disable before working on car!
AVERTISSEMENT
Co véhicule est équipé d'un systéme de démarrage á distance. Mettez-le hors
fonctuin avant d'eflectuer toule opération d'entretian ou de répanation!
2 Protected by
DesignTech Labels
© 2005 Directed Electronics, Inc.
Ready Remote
Remote Control Car Starter Installation Manual
www.designtech-intl.com • www.directed.com • 800-876-0800
PLEASE READ ENTIRE MANUAL CAREFULLY BEFORE BEGINNING
Electrical
Tape
Screwdriver
Drill with
1 / "and 5 /
4 16
drill bits
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Yellow Butt Connector
®
Model 23927

Features:

• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes
(programmable) if you forget to come out to your car.
• Will shut off if the brake pedal is pushed, the hood is opened, or
the transmission is shifted out of park - unless the key is in the
ignition and in the "run" position.
• Is quality engineered and microprocessor controlled to
provide many years of reliable use.
• Allows you to control up to 4 vehicles with Ready Remote
Car Starters
• Comes with a Limited Lifetime Warranty.
Power Harness
"
In-Gear Switch (inside case)
ON/OFF Switch Jack
Control Harness
Color Function Circuit Type
White/Black Ignition #3 (–) 400 mA
Brown/White Alarm Disarm (–) 400 mA
Brown Trunk (–) 400 mA
Blue Horn (–) 400 mA
Yellow Lights (+) Relay Output No
White - Option
Red LED Light
Red - Code Learn
Color Function
Orange Brake
Purple Hood Switch
Green Alarm/Tach
Red/White Lock
Red/Black Unlock
* For free vehicle specific wire information consult our
websites at www.designtech-intl.com or www.directed.com
1

Wiring Diagram

Circuit
Color Function Type
Pink Power (+12V) Input
White Accessory Relay output
Yellow Starter Relay output
Blue Ignition 1 Relay output
Green Ignition 2 Relay output
Black Ground Input
Required
Consult Wiring Guide*
Consult Wiring Guide*
No
No
Circuit Type Required
(+) Input Yes
(-) Input Yes
(-) Input No
400mA Output No
400mA Output No
® Remote
Required
Yes
Yes
Yes
Yes
Consult Wiring Guide*
Yes
Coax
Antenna Jack
v5.3 (27)