Table of Contents
Advertisement
H2 Harness - 8 pin connector
___
GREEN
H H 2 2 / / 1 1
___
BLUE
H H 2 2 / / 2 2
___
RED/BLACK
H H 2 2 / / 3 3
___
YELLOW/GREEN
H H 2 2 / / 4 4
___
GREEN/WHITE
H H 2 2 / / 5 5
___
BROWN
H H 2 2 / / 6 6
___
YELLOW/BROWN
H H 2 2 / / 7 7
___
H H 2 2 / / 8 8
GRAY/BLACK
Pin #
Color
H2/1
Green
H2/2
Blue
H2/3
Red/Black
H2/4
Yellow/Green
H2/5
Green/White
H2/6
Brown
H2/7
Yellow/Brown
H2/8
Gray/Black
© 2006 Directed Electronics
(-) 400mA RAP, Domelight, Starter Kill
Note
Use this wire if the vehicle fails to start correctly in
voltage mode
Negative output to horn or siren circuit. If your horn is
positive, use a relay.
Used on diesel engines only. Connects to wait-to-start
wire
Ignition output. Connect this wire to the ignition input
of an aftermarket alarm system.
Trunk release wire. Connect this wire to trunk release
wire listed on your vehicle specific printout.
Retained accessory shutdown or factory rearm output.
Connect this wire to factory arm wire if equiped or to
door trigger wire if your vehicle's accessories stay on
after remote start finishes cycle.
Headlight output. Connect this wire to headlight wire
in car. If headlights are positive, a relay is required.
Door trigger input. This wire connects to the door trig-
ger wire in your car to set off alarm when system is
armed and door is opened.
Tachometer input
(-) 400mA horn/siren output
(-) wait-to-start input
(+) ignition output
(-) 400mA trunk release output
(-) 400mA headlight output
(-) door trigger input
9
Advertisement
Table of Contents
