H1 Harness - 6 Pin Connector - Directed Electronics READY REMOTE 24926 Owner's Installation Manual

H1 Harness - 6 pin connector

___
YELLOW
H H 1 1 / / 1 1
___
BROWN/WHITE
H H 1 1 / / 2 2
___
VIOLET
H H 1 1 / / 3 3
___
ORANGE
H H 1 1 / / 4 4
___
WHITE/BLACK
H H 1 1 / / 5 5
___
H H 1 1 / / 6 6
RED/WHITE
Pin # Color
H1/1 Yellow
H1/2 Brown/White
H1/3 Violet
H1/4 Orange
H1/5 White/Black
H1/6 Red/White
8
Note
Selectable positive or negative parking light output
Use this wire if the vehicle is equipped with a
factory alarm. Connect to disarm wire listed on your
sheet.
Connect this wire to supplied hood pin switch
Connect this to wire in vehicle that shows 12 volts
when brake is pressed
Provides a ground during remote start. This wire is
normally connected to a bypass module if your
vehicle needs one.
This wire will start the vehicle when it sees two
negative pulses. Only used when incorporating into
existing alarm or for testing purposes.
(+/-) parking light output
(-) factory disarm output
(-) hood pin shutdown input
(+) brake switch shutdown input
(-) 400mA status output
(-) remote start activation input
© 2006 Directed Electronics