Canon CLC 1120 Service Handbook page 46

CHAPTER 2 STANDARDS AND ADJUSTMENTS
G. Paper Deck
Mounting the Paper Level
1
Indicator
If you have moved the paper level
indicator drive belt behind the front cover or
the deck lifter when removing the front cover,
perform the following to correct its position:
1) Move down the deck lifter to the lower
limit.
2) Move the drive belt [1] behind the front
cover by hand lightly in the direction of
the arrow until it stops (so that the white
area in the window [2] increases).
3) Mount the front cover [3].
If you operate the deck without matching
the paper level indicator and the deck
lifter, you can damage the drive system of
the paper level indicator. Exercise care.
Adjusting the Left/Right
2
Registration of the Deck
If the left/right registration is 0 ± 2.0 mm,
adjust the position of the latch plate [1] with
two screws [2]. (At this time, use the
graduation [3] on the latch plate as a guide.)
2-28
Figure 2-55
Figure 2-56
[1] [3]
(rear left of compartment)
Figure 2-57
[2]