Canon CLC 1120 Service Handbook page 168

CHAPTER 4 SERVICE MODE
COLOR
Adjusts the color balance.
Level 3
ADJ-Y Use it to correct the color balance of each color
ADJ-M selected by the user.
ADJ-C • Be sure to set the user color balance to '0' before
ADJ-K using this item.
(Note 1) • Be sure to follow the Image Adjustment Basic
Procedure.
OFST-Y Use it to adjust the color balance and density of light
OFST-M areas of each color.
OFST-C • Be sure to follow the Image Adjustment Basic
OFST-K Procedure.
(Note 1) • To increase the degree of reproduction of
extremely light areas, decrease the setting.
P-ADJ-Y Use it to correct the color balance of each color
P-ADJ-M when output is from an external image controller.
P-ADJ-C • Be sure to set the user color balance to '0' before
P-ADJ-K using this mode.
(Note 1) • Be sure to follow the Image Adjustment Basic
Procedure.
P-OFST-Y Use it to adjust the color balance and the density of
P-OFST-M light areas of each color when the output is from an
P-OFST-C external image controller.
P-OFST-K • Be sure to follow the Image Adjustment Basic
(Note 1) Procedure.
• If fogging is noted, increase the value.
• To increase the degree of reproduction of
extremely light areas, decrease the setting.
Note 1: Execute this mode upon replacement of a CPU PCB or initialization of the RAM. The settings
will be returned to standard settings, requiring you to enter the appropriate settings. Be sure to
record any new settings on the service label.
4-82
Description
COPIER>ADJUST
Remarks
-8 to +8
Standard:
M=0, C=0, Y=0, K=0
+ side: darkens
- side: lightens
-16 to +16
Standard:
M=0, C=0, Y=0, K=0
-8 to +8
Standard:
M=0, C=0, Y=0, K=0
+ side: darkens
- side: lightens
-16 to +16
Standard
M=0, C=0, Y=0, K=0