Canon CLC 1120 Service Handbook page 188

CHAPTER 4 SERVICE MODE
INSTALL
Used at time of installation.
Level 3
SPLY-Y Use it to rotate the developing cylinder to supply a
SPLY-M specific color developer to the developing assembly.
SPLY-C Using the Item
SPLY-K 1) Select an item (to highlight), and press the OK
key.
2) To stop, press the Stop key.
STIR-Y Use it to stir the developer inside a specific color
STIR-M developing assembly.
STIR-C Using the Item
STIR-K 1) Select an item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 2
min.
STIR-4 Use it to stir the developer in the four developing
assemblies in sequence.
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 9
min.
INIT-Y Use it to read the initial value of a specific toner
INIT-M concentration signal SGNL, REF.
INIT-C · The screen (COPIER>ADJUST>DENS) will
INIT-K show the reading. Be sure to record it on the
service label.
Using the Item
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 2
min.
INIT-4 Use it to read the initial value of the four color toner
concentration signals SGNL, REF in sequence.
· The screen (COPIER>ADJUST>DENS) will
show the readings. Be sure to record them on the
service label.
Using the Item
1) Select the item (to highlight), and press the OK
key.
2) The operation will stop automatically in about 9
min.
RECV-Y Use it to rotate the developing cylinder, thereby
RECV-M drawing the developer from a specific color
RECV-C developing assembly.
RECV-K Using the Item
1) Select an item (to highlight), and press the OK
key.
2) To stop, press the stop key.
Note:
You will use this mode during installation.
4-102
Description
COPIER>FUNCTION
Remarks