CHAPTER 2 STANDARDS AND ADJUSTMENTS
Caution:
1. Fix the side of the transfer drum sheet
with a long hole temporarily in place
so that that the gap between the left
side of the transfer drum sheet and
the edge of the transfer ring is about
0.5 mm.
2. Then, lightly pull the transfer drum
sheet to the right so that the middle of
the sheet will not become slack, and
attach the right side of the sheet
where a round hole is found.
3. At this time, check to make sure that
the right edge of the transfer drum
sheet will not overlap the edge of the
transfer ring; otherwise, shift the left
side of the sheet where a long hole is
found, and start over with step 2.
6) Let the transfer drum sheet drop on its
own weight, and remove the backing
paper from both sides of the sheet.
7) without holding the transfer drum sheet,
turn the front side of the transfer ring to
wrap it around the transfer drum.
2-20
Pull lightly to remove
the slack in the middle.
No overlapping.
Transfer rings
Figure 2-42
Figure 2-43
Figure 2-44