Canon ColorPASS-Z20e Service Manual page 74

CHAPTER 4 DISASSEMBLY/ASSEMBLY
3. Pull the battery out of its socket and release the clip.
4. To insert a new battery, slide the battery into the socket under the clip with the positive
(+) side facing up.
Make sure the clip holds the battery securely in the socket.
5. Reassemble the ColorPASS and verify its functionality as described on page 4-10.
When you power on the ColorPASS, let the Start-up diagnostics complete,
then power off and on again to reinitialize the realtime clock.
6. Reassemble the ColorPASS and verify its functionality (see "Restoring ColorPASS
functionality after service" on page 4-10).
7. Configure the time and date in Setup.
When replacing the motherboard battery, be sure to use the following items:
CR2032
Replace the motherboard battery only with the one listed in the Parts Cata-
log. Use of different battery may present a risk of fire or explosion.
The battery may present a fire or chemical burn hazard if mistreated. Do not
recharge, disassemble, or dispose of it in fire.
Keep the battery out of reach of children and discard any used battery
promptly.
4-26
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000