Canon ColorPASS-Z20e Service Manual page 69

d. To Complete and Verify Motherboard Installation
1. If you replaced the motherboard, insert the BIOS chip with the socket mount from the
motherboard you removed into the BIOS socket on the replacement board.
2. Attach the board mounting bracket screws for boards installed in back panel slots.
Make sure unused slots have slot covers installed. Uncovered slots reduce
air flow and could cause the ColorPASS to overheat.
Memo
3. Press down on each cable connector and verify that all cables are attached properly.
4. Check motherboard jumper settings. See "Motherboard jumpers" on page 4-29.
5. Reassemble the ColorPASS and verify functionality (see the connection verification
steps described in "Restoring ColorPASS functionality after service" on page 4-10).
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-21