Canon ColorPASS-Z20e Service Manual page 37

1.3.2 Checking Scanning and Printing
The Test Scan/Print function scans whatever is placed on the copier glass and prints it to
the copier. This test can be used to check the scanning capabilities of the ColorPASS. You
can compare the original with the output to make sure the connection between the
ColorPASS and the copier is working properly.
a. To Run Test Scan/Print
1. Place the document that you want to scan on the copier glass.
2. At the Idle screen, press the menu button once to display the Functions menu.
3. Select Run Diagnostics from the Functions menu.
4. At the Diagnostics screen, select Test Scan/Print.
The message Scanning from copier and printing.... is displayed.
5. When the ColorPASS is finished printing, compare the output from the copier to the
original.
COPYRIGHT© 2000 CANON INC.
Print Pages
Suspend Printing
Resume Printing
Shut Down
Functions
Clear Server
Run Setup
Run Diagnostics
Calibration
Functions
F03-103-02
Test Scan/Print
Test I/F board
Functions
F03-103-03
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 3 INSTALLATION
Use the line selection
button to the right to
select Run Diagnostics.
Select Test Scan/Print
3-5