Video Board; To Remove The Video Board - Canon ColorPASS-Z20e Service Manual

CHAPTER 4 DISASSEMBLY/ASSEMBLY

5.3 Video Board

The video board in the ColorPASS (see F04-503-01)provides the interface
between the ColorPASS and the copier.
The board is installed in connector PCI2 on the motherboard. The copier interface con-
nector on one side of the board (occupying slot 3 on the back panel of the ColorPASS) con-
nects to cable that attaches to the copier.
Daughter card installed on the
front side of the board
100-pin copier
interface connector

5.3.1 To Remove the Video Board

1. Power off and open the ColorPASS as described in "To shut down the ColorPASS" on
page 4-4 and "To open the ColorPASS" on page 4-5.
2. Make sure the copier interface cable connected to the back of the ColorPASS is re-
moved.
3. Remove the board mounting bracket screw that secures the board.
4. Remove the video board from motherboard connector PCI2.
Grasp the board at the front and back edge and gently pull it straight out of its connector
on the motherboard.
5. Place the board in an antistatic bag.
4-14
To connector PCI2 on
motherboard
F04-503-01 Diagram of video board
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000