To Connect A Twisted Pair Cable To The Colorpass - Canon ColorPASS-Z20e Service Manual

1.5.1 To Connect a Twisted Pair Cable to the ColorPASS

1. Power off the ColorPASS before connecting it to any network device.
If the system has just finished processing, wait 5 seconds after the system reaches the
idle state before using the power switch to power off the unit.
2. Connect the network cable to the RJ-45 connector on the back of the ColorPASS.
A Category 5 unshielded twisted pair cable network cable must be used for 100BaseT.
3. Configure Setup options.
It is the network administrator's responsibility to configure Setup according to the net-
work and user environment. Refer the network administrator to the Configuration Guide
for Setup information.
4. After configuring Setup options, verify the network connection.
Once the network connection has been made and the ColorPASS has the correct Setup
configuration, the ColorPASS should be available on the network.
The network administrator should perform any additional network setup, verify the net-
work connection, verify that the ColorPASS appears in the list of printers, and print a
few test documents from a networked computer that will use the ColorPASS. (See the
Configuration Guide for more information.)
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 3 INSTALLATION
3-7