To Replace The Video Board - Canon ColorPASS-Z20e Service Manual

5.3.2 To Replace the Video Board

1. Reseat the video board in motherboard connector PCI2. The component side of the
video board should be facing the copier.
The video board connector is keyed to fit only one way when properly oriented.
2. Attach the board mounting bracket screws to the bracket.
3. Reassemble the ColorPASS and verify its functionality (see the connection verification
steps described in "Restoring ColorPASS functionality after service" on page 4-10).
Be sure to connect the copier interface cable to the connector in slot 3.
COPYRIGHT© 2000 CANON INC. 2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-15