Canon ColorPASS-Z20e Service Manual page 101

eep code
B
1 long beep—Pause—short beeps
5 short beeps—Pause—1 long beep
6 short beeps—Pause—1 long beep
8 short beeps—Pause—1 long beep
9 short beeps—pause—1 long beep
10 short beeps —Pause—1 long beep
11 short beeps—Pause—1 long beep
Some beep codes continue to loop until the ColorPASS is powered off and
the error is corrected.
Memo
COPYRIGHT© 2000 CANON INC.
Area reporting
the error
Battery
DIMMs
CMOS settings
DIMMs
T05-202-01ColorPASS beep codes
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 5 TROUBLESHOOTING
Suggested action
• Replace the battery on the motherboard.
• Make sure you reset the time and date in
Setup after replacing the battery.
• Make sure all DIMMs installed on the
motherboard are Canon approved with
part number 45005190.
• Reseat all DIMMs in their sockets and
restart the ColorPASS in order to run the
startup diagnostics.
• If the error persists, replace each DIMM
one at a time with a good DIMM until you
locate the faulty DIMM(s).
• If the above does not correct the error, you
may need to replace the motherboard.
• Reboot the ColorPASS.
• If the problem persists, replace the battery
on the motherboard.
• If the problem still persists, you may need
to replace the motherboard.
NOTE: If you replace the battery, reset the
time and date in Setup after replacing the
battery.
• Make sure all DIMMs installed on the
motherboard are Canon approved
(DIMMS should be Canon part number
45005190).
• Reseat all DIMMs in their sockets and
restart the ColorPASS in order to run the
startup diagnostics.
• If the error persists, replace each DIMM
one at a time with a good DIMM until you
locate the faulty DIMM(s).
• If the above does not correct the error, you
may need to replace the motherboard.
5-9