Remote Indoor Temperature Sensor; Two-Piece Thermidistat Control Configuration - Bryant PREFERRED T6-PRH-A Installation Instructions & Replacement Parts List

Remote Indoor Temperature Sensor

A remote temperature sensor may be used with the programmable model, where
it is desirable to install the Thermidistat Control in a limited access location while
measuring the temperature in the living space. The remote room sensor may be
used as a stand alone or average with local sensor.
Two- - Piece Thermidistat Control Configuration
The Preferred Series Thermidistat Control can be installed in one of two
configurations. The control may be installed as a single- -piece Thermidistat or it
may be split into two pieces and mounted in separate locations. As a single- -piece
unit, all required wiring must be brought to the Equipment Control Module for
connection to the terminal strip. In two- -piece configuration, the Display Module
can be mounted in the living space while the Equipment Control Module may be
mounted near the indoor furnace or fan coil. Connection from the display to the
Equipment Control Module requires only two wires. All other control wires are
connected to the Equipment Control Module from the HVAC equipment. This
configuration results in a slimmer display and locates the Equipment Control
Module containing the switching relays away from the main living space where
relay clicking will not be heard.
7