Backplate Mounting - Illustration - Bryant PREFERRED T6-PRH-A Installation Instructions & Replacement Parts List

Preferred series thermidistat programmable / non-programmable control

Hide thumbs Also See for PREFERRED T6-PRH-A:

Table of Contents

Enlarged version

2. Route wires through large hole in mounting base. Level mounting base

against wall (for aesthetic value only—Display Module need not be lev-

eled for proper operation) and mark wall through 2 mounting holes. See

Fig. 6.

Fig. 6 - - Backplate Mounting

3. Drill two 3/16- -in. mounting holes in wall where marked. Thermidistat

Control may be mounted to a standard junction box, if desired. Hole pat-

tern on Thermidistat Control mounting base matches junction box mount-

ing holes.

4. Secure rear plastic mounting base to wall with 2 screws and anchors pro-

vided. Additional mounting holes are available for more secure mounting

if needed. Make sure all wires extend through hole in mounting base.

5. Adjust length and routing of each wire to reach proper connector block

and terminal on mounting base with 1/4- -in. extra wire.

A07165

Table of Contents

Show Quick Links

Table of Contents

Preferred t6-nrh-a A07045 A07044