Standoff View - Bryant PREFERRED T6-PRH-A Installation Instructions & Replacement Parts List

Preferred series thermidistat programmable / non-programmable control

Hide thumbs Also See for PREFERRED T6-PRH-A:

Table of Contents

Enlarged version

NOTE: Standoffs are provided as an aid when installing Equipment Control

Module on inside equipment or a solid wall.

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the Thermidistat Control mounting base. If wires are con-

nected incorrectly, the Display Module will not operate. See Fig. 7, 8 and

13. Snap cover over top of Equipment Control Module. See Fig. 13.

Fig. 12 - - Standoff

A07227

Table of Contents

Show Quick Links

Table of Contents

Preferred t6-nrh-a A07045 A07044