Set Thermidistat Control Configuration - Bryant PREFERRED T6-PRH-A Installation Instructions & Replacement Parts List

Set Thermidistat Control Configuration

Configuration options enable the installer to configure the Thermidistat Control
for a particular installation. Most are not presented to the homeowner and
therefore must be properly set by the installer. (Only those marked with an
asterisk * below are available to the homeowner.) The homeowner
configurations are described in the owner's manual. A special procedure allows
entry into the configuration mode. While in configuration mode, up to 33
selections can be made. Description of each selection and how to use the
configuration mode follows.
CONFIGURATION OPTIONS - - SUMMARY
Option 01 — Equipment Type
Option 02 — Clean Filter Timer Adjustment
Option 03* — Fahrenheit/Centigrade Selection
Option 04 — Fan (G) on with W/W1 Selection
Option 05 — Room Air Temperature Sensing (programmable
models only)
Option 06 — Cooling Lockout Below 55_F/13_C Selection (only
available if outdoor air sensor is present)
Option 07 — Zoning
Option 08 — Auxiliary Heat Lockout Temperature Setting (only
available when heat pump is used and when
outdoor air temperature sensor is present)
Option 09 — Heat Pump Lockout Temperature (only available when
outdoor air temperature sensor is present)
Option 10 — Reversing Valve
24