To Enter Configuration Mode; While In Configuration Mode - Bryant PREFERRED T6-PRH-A Installation Instructions & Replacement Parts List

Option 31* — Daylight Savings Time Configuration
(programmable models only)
Option 32 — Furnace Heat Staging
Option 33 — Single or Two- -Piece Installation
Option 40 — Fan Humidify
Option 41 — Variable Speed Blower
Option 42 — Variable Speed Super Dehumidification
Option 43 — Intelligent Heat Staging
Option 44 — Super Comfort Heat
Option 99 — Reset to Factory Defaults

TO ENTER CONFIGURATION MODE

Press and hold FAN button for approximately 10 sec. The Display Module is
now in configuration mode. It will automatically exit this mode if no button is
pressed for 3 minutes. Pressing the DONE button will exit configuration mode
immediately.

WHILE IN CONFIGURATION MODE

The option number is displayed in the heat setpoint location and the
configuration setting is displayed in the cool setpoint location. On the
T6- -PRH- -A (programmable) model, a box will surround the option number. The
mode button is used to move the box between the two displayed values. The soft
keys below the listed values may also be used to move the box between selected
values. The value inside the box is changed by using the UP/DOWN buttons. On
the T6- -NRH- -A (non- -programmable) model, one of the values will be flashing.
The mode button is used to change which value is flashing or the Home and
Sleep buttons may also be used to select which value to flash. The value that is
flashing is changed by using the UP/DOWN buttons. All changes made are
26