Standoff - Bryant PREFERRED T6-NAC Installation Instructions Manual

Preferred series ac/hp thermostat

Hide thumbs Also See for PREFERRED T6-NAC:

Table of Contents

NOTE: Standoffs are provided as an aid when installing Equipment Control

Module on inside equipment or a solid wall.

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 7, 8 and 9.

13. Snap cover over top of Equipment Control Module. See Fig. 13.

Fig. 12 − Standoff

A07227

Table of Contents

Show Quick Links

Table of Contents

Preferred t6-nhp Preferred t6-pac Preferred t6-phpPreferred t6-pac seriesPreferred t6-php seriesPreferred t6-nac series ... Show all