Resetting The Network Board - Canon LASER SHOT LBP-3600 User Manual

6
7
8
9

Resetting the Network Board

If you want to reset the network board to the default values, use Remote UI or FTP
6
client. For details on Remote UI, see "Chapter 3 Various Functions of Remote UI" in
Remote UI Guide, and on FTP client, see "Chapter 5 Appendix" in Network Guide.
Even if none of the above procedures work, you can reset the settings for the
network board by manipulating the DIP switches using the following procedure. A
Phillips screwdriver is required to reset the settings for the network board. Have one
that matches the size of the screws available.
1
2
3
6-48 Network Board
Secure the top and bottom portions of the network board with
the 2 screws supplied with the network board.
Connect the LAN cable.
NOTE
If the optional duplex unit was previously installed, reinstall it on the printer. For
details on the procedure for installing the duplex unit, see "Installing the Duplex
Unit," on p. 6-32.
Connect all interface cables and the power cord to the printer.
Plug the power plug into the AC power outlet.
Press " " of the power switch to turn the printer OFF, then
unplug the power plug from the AC power outlet.
Remove all interface cables and the power cord.
NOTE
If the optional duplex unit is installed, remove it from the printer. For details on
removing the duplex unit, see "Removing the Duplex Unit," on p. 6-34.
Remove the 2 screws and remove the network board.
IMPORTANT
Do not touch the network board parts, printed wire, or connectors with your hands.