Removing The Duplex Unit - Canon LASER SHOT LBP-3600 User Manual

6
7
6

Removing the Duplex Unit

Remove the duplex unit using the following procedure. Have ready the top rear
cover and bottom rear cover removed from the printer when the duplex unit was
installed.
WARNING
Be sure that the power switch of the printer is turned OFF, the power cord is
unplugged, and all interface cables and power cord are disconnected from the
printer before removing the duplex unit. Otherwise, the power cord or interface
cables may be damaged, resulting in a fire or electrical shock.
IMPORTANT
When moving or servicing the printer, remove the duplex unit.
6-34 Duplex Unit
IMPORTANT
Do not touch the duplex unit connector, as this may result in damage to the printer
or printer error.
Connector
Connect all interface cables and the power cord to the printer.
Plug the power plug into the AC power outlet.
NOTE
After installing the duplex unit, you have to specify the settings for the optional
accessories in the [Configuration]/[Device Settings] sheet in the printer driver. You
can obtain the status of the optional accessories automatically by clicking the [Get
Device Status] button in the [Configuration]/[Device Settings] sheet.