Brother SC-2000 Service Manual page 82

(10) Open the presser plate, then tighten two screws, as shown in Fig. 3.74C.
Note 9: Tighten those screws twice.
Screws
(11) Remove the presser jig assy (part of the presser base assy) and adjustment jig.
(12) Attach the presser plate cover to the presser plate, as shown in Fig. 3.74D.
Note 10: Check that two hooks and locating pins of the presser plate cover fit in
the
Presser plate cover
Fig. 3.74C
holes of the presser plate.
Hooks
Fig. 3.74D
III - 60C
Presser plate
Adjustment jig
Main chassis
Locating pins
Presser plate
Main chassis