Brother SC-2000 Service Manual page 79

(6) Place the presser jig assy on the presser frame sub assy, as shown in Fig.
3.73A.
Note 6: Before securing the presser jig assy, check the following items.
Presser jig assy
(part of the presser base assy)
* Check that the presser frame sub assy is aligned with the main chassis at four
portions (C), with no gap being allowed between them, as shown in Fig. 3.72C.
* Check that the harnesses including the FPC are not caught between the presser
jig assy and presser frame sub assy.
* Check that the presser frame sub assy and main chassis fit in four dented portions
(D) on the presser side plates R/L of the presser jig assy, as shown in Fig. 3.73A
and Fig. 3.73B.
D
Presser hook
Presser frame sub assy
Presser side plate
D
Catch clip assy
Fig. 3.73A
F
(It is impossible to check
the item by taking a look.)
Presser side plate
Fig. 3.73B
III - 59C
Presser hook base
Presser side plate
Presser hook
Presser hook base
D
Main chassis
D
Presser frame sub assy
Main chassis
Presser hook