Brother SC-2000 Service Manual page 75

Pass the positioning shaft through the presser plate and the positioning presser
plate, and set the retaining rings on both ends of the positioning shaft.
Pass the presser plate lock shaft through the hole in the presser lever from the
outside in the direction of the arrow.
Pass it through the presser plate lock, the presser plate lock spring, and through the
hole on the opposite side of the presser lever.
Insert hook A of the presser plate lock spring into the hole C in the presser lever.
Pass the presser plate lever shaft through the presser plate and the presser lever.
Set the presser bearings on both ends of the presser plate lever shaft.
Set the presser lever cover on the presser lever.
Note 2: Make sure that two hooks B of the presser lever cover and the two locating
pins are properly set, as shown in Fig. 3.70.
Presser lever
cover
Presser bearing
Presser lever
Presser plate
lock spring
Presser plate lock
Positioning presser plate
B
A
Presser plate
Fig. 3.70
III - 57
C
Presser plate lever shaft
Presser plate lock shaft
Presser bearing
Positioning shaft