Brother SC-2000 Service Manual page 108

Error mode
A draft sheet or an Is the
ID label is fed, but connector
no printing is of the
performed. thermal
head dis-
connected?
The presence or Does the size of a
size of the holder holder match that of
can not be a stamp to be
detected. manufactured?
Is the holder set in
the correct position?
Non of the above
The printing surface Is the printing surface
is insufficiently of the holder flawed
fused after or dented?
engraving stamp.
Is the surface of the
transparent plate of
the xenon unit dirty?
Is the presser unit set
at a specified height?
Non of the above
Checking method
YES
NO
Cause
Disconnected Connect the
connector of the connector of the
thermal head thermal head.
Defective head or
PCB
Incorrect size of a Set a holder
holder whose size
matches the size
of a stamp to be
manufactured.
Holder set in the Set the holder in
incorrect position the correct
position.
Defective PCB
Defective printing Engrave stamp
surface of the with a new holder.
holder
Dirty surface of Clean the surface
the transparent with a soft cloth.
plate (If the dirt or blur
can not be
removed, replace
the xenon unit.)
Insufficient Adjust the height
pressure of the presser unit
with the setting
presser jig assy
and adjustment
jig.
Insufficient light Replace the
emitted by the xenon unit.
xenon lamp
Replace the
capacitor box.
IV - 5
Action Service manual
CHAPTER III
2.17
Reassembly of
the Main PCB
Assy
Electronic part
Electronic part
CHAPTER III
2.8
Reassembly of
the Presser Unit
Assy
CHAPTER III
1.2
Disassembly of
the Magazine
Tray and the
Xenon Unit
2.19
Reassembly of
the Xenon Unit
CHAPTER III
1.5
Disassembly of
the Capacitor
Case
2.16
Reassembly of
the Capacitor
Case
_
_
_
_