Brother SC-2000 Service Manual page 61

Set the sensor bracket on the two locating pins on the label guide, and secure the
sensor bracket on the label guide with the two screws.
Set label nip spring L on the pin on the label guide, and set the two hooks of the
label nip spring L in hook A and then hook B of the label guide.
Set the ribbon cassette shaft on the label guide, and set the two retaining rings on
the ribbon cassette shaft.
In the same manner, set label nip spring R, as shown in Fig. 3.57.
Label guide
Locating pin
A
Label nip spring L
B
Ribbon cassette roller
Fig. 3.57
III - 43
Label nip
Sensor bracket
spring R
Locating pin
Screws