(3) Open the presser plate, then place the adjustment jig in the presser sub unit
assy, as shown in Fig. 3.72C.
(4) Close the presser plate.
Note 5: Check that the presser plate is locked (B), as shown in Fig. 3.72D.
Presser sub unit assy
Presser plate lock
(5) Align the presser frame sub assy with the main chassis at four portions (C),
with no gap being allowed between them, as shown in Fig. 3.72C.
Fig. 3.72C
Presser frame shaft
B
Fig. 3.72D
III - 59B
Adjustment jig
Presser plate
Presser frame sub assy
Main chassis
Main chassis