Clear All Memory (Stx Q); Set Continuous Label Spacing (Stx S) - Brady TLS PC Link Programmer's Manual

This sample creates a label format with "TEST1" placed at the upper left corner
of the label, and "TEST2" placed 1" below this. The first <STX>P sets the paper
length to 1". Thus, the following <STX>G will print this label only 1" long and
only "TEST1" will be printed. The second <STX>P command sets the paper
length to 0", thus putting it in banner mode. The following <STX>G command
will print both text strings and stop printing immediately after "TEST2".
Feedback Possibilities: 0,1,2

Clear All Memory (STX Q)

This command instructs the printer to clear all images from memory.
Sample:
<STX>Q
Feedback possibilities: 0,1,2

Set Continuous Label Spacing (STX S)

This command will set the label spacing for continuous material. The spacing
can be set down to zero. This command can be used with <STX>P to generate
desired label lengths and spacing for continuous material. If the label length is
set to zero using <STX>P (banner mode), this setting is ignored. A 1/4" spacing
is always used in banner mode. When the label length is set to non-zero, this
spacing is only used when printing batches, or in the special case where the feed-
to-cut function is disabled (<STX>C). See Examples section for an extensive
terminal block example.
<STX>Snnnn
Where:
nnnn-
Sample:
<STX>L
190000900000000TEST01<CR>
+001<CR>
X<CR>
<STX>P0050
<STX>S0000
<STX>E0003
TLS PC Link
a four-digit label length in in/100 or mm/10
TM
Programmer's Guide
21