Table of Contents
Advertisement
Service Manual PAM 3600
4.7
Replacing the Slip Clutches
The rewinders for the ribbon and the media and the brake for the ribbon supply hub are equipped with slip clutches.
A slip clutch has to be replaced when it can not longer be adjusted. The assembly instructions for the clutches also
have to be observed when a winder has to be replaced.
The winding torque of the clutch always has to be readjusted after replacing a clutch or if it has been disassembled
at any intermediate time.
WARNING!
Mortal danger by electric shock!
Disconnect power supply!
Switch off compressed air!
Figure 4g Slip clutches
1 Clutch of the ribbon take up hub
2 Motor for the ribbon take up hub
3 Clutch of the ribbon supply hub
4 Clutch of the internal rewinder
1.
Remove label stock and transfer ribbon from the printer.
2.
Remove the cover at the rear side.
3.
Replace the respective clutch as described on the next pages.
4.
Mount the cover at the rear side.
Printer Applicator System PAM 3600
4 Replacing Assembly Units
1
2
3
4
Advertisement
Table of Contents
