Changing Fax Resolution; Real Time Transmission - Ricoh Aficio SP C210SF User Manual

Chapter 5

Changing fax Resolution

After you load the document, you can use
Resolution to change the setting temporarily
(for this fax only). In Fax mode
Resolution and ▲ or ▼ to select the setting
you want, and then press Menu/Set.
—OR—
You can change the default setting.
1
If it is not illuminated in blue, press
(Fax).
2
Press Menu/Set, 2, 2, 2.
Setup Send
2.Fax Resolution
3
Press ▲ or ▼ to select the resolution
you want.
Press Menu/Set.
Note
You can choose four different resolution
settings for monochrome faxes.
Suitable for most typed
Standard
documents.
Good for small print and
Fine
transmits a little slower than
Standard resolution.
Good for small print or
S.Fine
artwork and transmits
slower than Fine resolution.
Use when the document
Photo
has varying shades of grey
or is a photograph. This has
the slowest transmission
time.
5 - 5

Real Time Transmission

When you are sending a fax, the machine will
scan the document into the memory before
sending. Then, as soon as the phone line is
, press
free, the machine will start dialling and
sending.
If the memory is full, the machine will send the
document in real time (even if
Real Time TX is set to Off ).
Sometimes, you may want to send an
important document immediately, without
waiting for memory transmission. You can set
Real Time TX to On for all documents or
Next Fax:On for the next fax only.
Sending in real time for all faxes
1
If it is not illuminated in blue, press
2
Press Menu/Set, 2, 2, 5.
Setup Send
5.Real Time TX
3
Press ▲ or ▼ to select On (or Off ).
Press Menu/Set.
(Fax).