Formatting Using Wiremarker Label Settings - Brady IDXPERT User Manual

While in the General ID Menu, the IDXPERT
to the General setting for most cartridges except those
containing self-laminating label material. In most cases,
you will only need to set label format to General if you
have been working in wiremarker mode. The current
format—Gen or Wire—is displayed on the status bar.
To work with General (non-wiremarker) labels:
Step 1. Press .
MENU
Step 2. Press the softkey beneath
Step 3. Press the softkey beneath
Format: General
Step 4. Press .
ENTER

Formatting Using Wiremarker Label Settings

When you create a wiremarker label, each line of text is
repeated as many times as will fit on the label.
Wiremarkers allow for full 360
printed information making this label type useful for
marking wires, cables, vials, tubes, or any cylinder.
Note: The alignment default for wiremarker text is CENTERED.
To work with Wiremarker labels:
Step 1. Press .
MENU
Step 2. Press the softkey beneath
Step 3. Press the softkey beneath
Format: Wire
Step 4. Press .
ENTER
For wiremarker labels, the text line(s) is repeated as many times as will fill the printable area.
This is automatically calculated by the smart-cell.
20
defaults
TM
.
FRMT
. The format style is shown on the display screen.
GEN
o
rotational viewing of the
.
FRMT
. The format style is shown on the display screen.
WIRE
123 123
123
ABC
123
123
123
ABC
User Manual