Table of Contents
Advertisement
Font Sizes
Fonts are available in these point sizes: 7, 10, 13, 20, 26, 38, 45, 51, 76, and 102. Symbols and
numbers can also be printed in these font sizes. The IDXPERT
pt. (1.25", 31.75mm) font for uppercase characters only.
Note: Refer to Appendix B Font Size Chart to view samples of the available font sizes.
Default Font Size
When a cartridge is loaded and the unit is turned on, the IDXPERT
information stored in the smart-cell. This information is used to automatically set an initial font size
for your label. The method used to set this default is intended to help approximate an optimal starting
point for sizing your text.
For continuous printed labels (banners), the default font size is the largest font that prints on the
selected marker width in horizontal orientation.
Changing the Font Size
The maximum font size selectable for a particular label line depends on several factors including label
size, number of characters of text entered on the label line, number of lines of text entered on the
label, and the font sizes chosen for the label lines.
The printer allows a maximum of 50 characters per line and 23 lines per label. These limits are
dependent on factors such as number and type of characters, font size, and label type.
To set or change a font size:
1. Press
The font size and bold status appear on the display screen.
FONT: 7pt
Bold: OFF
2. Use the softkey arrows or the arrows (up/down) on your keypad to change the font.
3. Press
Once the font is set for a label line, the size remains the same for any new lines that follow, and
remains at the size you choose until you decide to change it.
If you attempt to enter too many characters on a label line, you will receive this error message:
Cannot Fit. To allow more characters to fit on the line, you must decrease the font size.
12
.
.
Handheld Labeler also offers a 126
TM
printer reads the label size
TM
User's Manual
Advertisement
Table of Contents
