Olivetti CopyLab 200 User Manual page 41

Copy/print media is not loaded.
Copy/print media repeatedly jams
or the multifunctional copier tears
the corners.
Copied/Printed document is not
ejected.
More than one sheet of copy/ print
media is fed at a time.
Troubleshooting
The copy/print media you are using is:
1. too thick,
2. successive sheets are
together,
3. has not been loaded correctly in
the input tray.
1. The copy/print media is not held
correctly in the input tray.
2. The wrong size copy/ print media
is loaded.
3. The leading edge of the copy/print
media is damaged or bent, or the
media is not in perfect condition.
1. Multifunctional copier/ computer
switched off before copy/print
operation is completed.
2. Paper jam.
The media you are using has not been
fanned sufficiently.
If the sheet is jammed inside one of the feeders:
1. Cancel the current printing operation on the Printer Monitor Status
card and suspend the ones present in the printing queue.
2. Turn off the printer and unplug it from the power socket.
3. Remove the jammed sheet by pulling it gently from the rear of the
feeder.
4. Examine the sheets in the automatic sheet feeder and, if
necessary, eliminate any crumpled or torn sheets.
5. Repeat the paper loading procedure
6. Reconnect the printer to the power socket and turn it on again
7. Repeat the print command and reactivate those present in the
printing queue.
For a description of the paper loading procedure, see Loading Paper .
•
Make sure that there is not too much paper in the input tray.
•
Check that the paper is positioned correctly in the input tray.
•
Check that the size and weight of the paper you are using are within
the limits allowed.
•
Make sure the correct paper size, type and source is selected in the
Paper/Output tab of the Printer Monitor and/or in the Features
menu.
Remove all the copy/print media from the input tray and:
1. Check that it is within the specifications indicated for the media type
you are using,
stuck
2. Fan it thoroughly before reloading it in the input tray,
3. Reload it in the input tray and close the margin guides so that it
feeds without being held too tight or too loose.
1. Make sure the lateral guide on input tray is positioned correctly
against the paper edges.
2. Load the correct copy/print media size in input tray OR select the
correct setting for the currently loaded paper using the Paper key on
the operator panel/in Properties in multifunctional copier printer
driver.
3. Remove the sheet(s) that have caused the jam; remove all the
media from the input tray; check for and removed damaged or
curled paper; reload media in input tray.
1. Switch on multifunctional copier/computer. In some cases, your
computer may still have the copy/print job queued. You will be
request to confirm OK to complete. Otherwise, you will have to
start the copy/print job from the beginning.
2. See previous item 3.
Remove all the copy/print media from the input tray and fan it thoroughly
before reloading it.
41