Mains Charger; Charging - Benefon Track Pro 1.1 Manual

Hide thumbs Also See for Track Pro 1.1:
Table of Contents

Advertisement

MAINS CHARGER

The mains charger available for this phone
is quick charger CMA-70-230 with its cable
FMC-70.
The mains charger should only be used in-
doors. Make sure that the voltage in the
country which you are staying corresponds
to the voltage (230 V) of the charger.
When

charging,

connect
(round) end of the cable into the charger
and lock it by turning it half a turn clock-
wise. Plug the square end of the cable (with
the arrow facing up) into the left side of the
bottom connector on the phone.
Plug the charger into a mains outlet. Charg-
ing will start automatically.
The mains charger is usually provided with
the phone, but is also available from the as-
sortment of Benefon accessories.
Other charger types are introduced in the
chapter Accessories.
When you start using the phone for the first
time, you should charge the battery first.
Please note that the battery will reach its
full capacity only after two or three charg-
ing times.
The phone controls the charging status,
battery temperature and power supply dur-
ing the charging operation.
the
charger
The phone will turn on when the charger is
connected.
However, when charging a totally empty
battery, the phone might not turn on imme-
diately.
The phone and the battery can be left in the
charger even for several days without any
fear of damage.
The ideal temperature range for charging is
+10°...+30°C. If charging the battery above
or below these temperatures the life of bat-
tery may be shortened. Also, the battery
may not reach full capacity.
CHARGING
BATTERY: MAINS CHARGER
171

Advertisement

Table of Contents
loading

Table of Contents