Troubleshooting - Baby Lock emore BLMR Instruction And Reference Manual

Hide thumbs Also See for emore BLMR:
Table of Contents

Advertisement

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX

Troubleshooting

If the machine stops operating correctly, check the following possible problems before requesting service.
If the problem persists, contact your retailer or the nearest authorized service center.
Symptom
The machine is not turned on.
The "Start/Stop" button was not
pressed.
The machine does
not operate.
The presser foot lever is raised.
The embroidery unit is not
attached on the machine.
The needle is incorrectly installed. Correctly install the needle.
The needle clamp screw is loose.
The needle is bent or blunt.
The upper thread tension is too
tight.
The spool is incorrectly installed.
The area around the hole in the
needle plate is scratched, or has a
The needle breaks.
burr on it.
The area around the hole in the
presser foot is scratched, or has a
burr on it.
The bobbin case is scratched, or
has a burr on it.
A bobbin designed specifically for
this machine is not used.
78
Probable Cause
Remedy
Turn on the machine.
Press the "Start/Stop" button.
Lower the presser foot lever.
Attach the embroidery unit.
Use the screwdriver to firmly tighten
the screw.
Replace the needle.
Loosen the upper thread tension.
Correctly install the spool.
Replace the needle plate. Contact
your retailer or the nearest authorized
service center.
Replace the presser foot. Contact
your retailer or the nearest authorized
service center.
Replace the bobbin case. Contact
your retailer or the nearest authorized
service center.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
Reference
page 21
page 59
page 59
page 17
page 38
page 64
page 31
page 26

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents