Needle And Presser Foot Section; Right-Side/Rear View - Baby Lock emore BLMR Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Needle and presser foot section

a Thread guide disk
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
b Needle bar thread guide
Pass the upper thread through the needle bar thread
guide.
c Needle plate
When the needle is lowered, it enters the hole in the
needle plate.
d Needle plate cover
Remove the needle plate cover to clean the bobbin case
and race.
e Bobbin cover/bobbin case
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
f Embroidery foot "Q"
This presser foot is used for embroidering.

Right-side/rear view

a Handle
Carry the machine by its handle when transporting the
machine.
b Handwheel
Turn the handwheel toward you to raise and lower the
needle. Always turn the handwheel towards you
(counterclockwise).
c Embroidery card slot
Insert the embroidery card.
d USB port connector
Plug the USB cable into the USB port connector.
e Air vent
The air vent allows the air surrounding the motor to
circulate. Do not cover the air vent while the machine is
being used.
f Power supply receptacle
Insert the plug on the power cord into the power supply
receptacle.
g Main power switch
Use the main power switch to turn the machine ON and
OFF.
Memo
Refer to pages 10 through 13 while you are
learning to use your machine.
Names of Machine Parts and Their Functions 11