Baby Lock emore BLMR Instruction And Reference Manual page 32

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
• Be careful not to drop the bobbin.
d Insert the bobbin into the bobbin case so that
the thread unrolls to the left.
• Be sure to insert the bobbin correctly.
CAUTION
● Be sure to install the bobbin so that the
thread unwinds in the correct direction,
otherwise the thread may break or the
thread tension will be incorrect.
Memo
The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks around the bobbin case. Be sure to
thread the machine as indicated.
e Lightly hold down the bobbin with your right
hand, and then guide the thread as shown with
your left hand.
CAUTION
● When installing the bobbin, be sure to hold
it down with your finger. If the bobbin is
not correctly installed, the thread tension
will be incorrect.
30
f Pass the thread through the slot as shown, and
then pull the thread out toward the front.
1
a Cutter
The cutter cuts the thread.
Note
Make sure that the thread is correctly
inserted through the tension-adjusting spring
of the bobbin case. If it is not inserted
correctly, reinsert the thread.
a Tension-adjusting spring
g Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
The bobbin threading is finished.
Next, thread the upper thread. Continue with
the procedure in "Upper Threading" (page 31).
Memo
You can start embroidering without pulling
up the bobbin thread.
1
2