Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Memo
When embroidering with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
a
a Spool cap (small)
b Spool (cross-wound thread)
c Space
When using thread that winds off quickly,
such as transparent nylon thread or metallic
thread, place the spool net over the spool
before placing the spool of thread onto the
spool pin.
If the spool net is too long, fold it to fit the
size of the spool.
When the spool net is used, the tension of
the upper thread will slightly increase. Be
sure to check the thread tension. For details,
refer to "Adjusting the thread tension" (page
64).
1
3
a Spool net
b Spool
c Spool cap
d Spool pin
Slide the spool cap onto the spool pin.
g
Slide the spool cap as far as possible to the right,
as shown, with the rounded side on the left.
b
c
2
4
h
While holding the thread lightly with your
right hand, pull the thread with your left hand,
and then pass the thread behind the thread
guide cover and to the front.
a Thread guide cover
i
Pass the thread under the thread guide plate,
and then pull it up.
a Thread guide plate
j
While using your right hand to lightly hold the
thread passed under the thread guide plate,
pass the thread through the thread path in the
order shown below.
1
a Shutter
1
1
Upper Threading 33
1
Hide quick links:
Advertisement
Table of Contents
