Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Symptom
Machine does not
operate when
button is pressed.
Embroidery unit
does not move.
Embroidering
continues
although the
bobbin thread ran
out.
Embroidery not
neatly done.
Probable Cause
An animation is displayed on the
LCD.
No pattern selected.
The embroidery unit is not set up
correctly.
Dust has collected on the bobbin
thread sensor.
The fabric is not fully stretched on
the embroidery frame. The fabric
is loose.
No stabilizer material is attached.
The thread is tangled and the
bobbin case, etc., is plugged up.
The thread tension is incorrect.
Objects are placed near the
carriage or embroidery frame.
Material coming out of the
embroidery frame is causing
problems.
A heavy fabric is being
embroidered, and the fabric is
hanging off the table.
The fabric is catching. It is
pinched.
The carriage was moved while the
embroidery frame was being
removed or attached during
embroidery.
Remedy
Touch the LCD with your finger, and
the animation will disappear.
Select a pattern.
Set the embroidery unit up correctly.
Remove any dust from the bobbin
thread sensor.
Stretch the fabric properly on the
embroidery frame.
Always use stabilizer material for
embroidery with stretch fabrics, thin
fabrics, fabrics with a loose weave
and fabrics where stitches easily
contract.
Remove the tangled thread. When
the bobbin case is plugged up, clean
the race and the bobbin case.
Adjust the tension of the upper
thread.
If the embroidery unit carriage or
embroidery frame bumps into objects,
the pattern will be misaligned. Do not
place objects within the range of
embroidery frame motion.
Stretch the fabric on the frame once
again so that the material coming out
of the embroidery frame does not
cause problems, rotate the pattern
and embroider.
If embroidery is done with the fabric
hanging off the table, the embroidery
unit movement will be impaired.
Support the fabric while embroidering.
Stop the machine and set the fabric
up correctly.
If the carriage is moved during the
process, the pattern may be misaligned.
Be careful when removing or
attaching the embroidery frame.
Reference
page 22
page 50
page 17
page 74
page 45
page 44
page 74,
page 75
page 64
page 18
–
–
–
–
Troubleshooting 81
3
Hide quick links:
Advertisement
Table of Contents
