AT&T MERLIN 3070 Administration Manual page 40

When your system is first set up, all your voice terminals have access to all the line
pools in the system. Follow the procedure below to assign voice terminals Dial Access
to particular line pools.
1. If you have not already done so, enter administration mode by follow-
ing the boxed instructions on page 25.
2. Touch Adm Tel.
The lights next to the administration mode buttons stop flashing, and the
green light next to Adm Tel remains on.
3.
Dial the intercom number (16,
button for the voice terminal to which you want to assign Dial Access
to selected line pools.
If the voice terminal is idle, a steady green light comes on next to its Auto
Intercom button, and the system gives you the 2-beep signal to begin.
If the voice terminal is being used, the green lights next to the Auto
Intercom button and Adm Tel flash rapidly. You must
lights become steady or try again later.
Refer to your Voice Terminal Configuration Form to see to which pools
4.
this voice terminal should have Dial Access. Steady green lights come
on next to the buttons of the lines assigned to this voice terminal. Steady
red lights come on next to the buttons of each line assigned to one of
the system pools.
5. Touch the same Auto Intercom button or dial the same intercom number
again.
A steady red light comes on next to the green light beside Adm Tel.
If you are trying to assign Dial Access to
console or if the voice terminal is busy, the red light will not come on
and the system will beep. You won't be able to perform this procedure.
6. Touch the button next to one of the lines in each of the pools whose
status you want to change. The green light beside the button for the line
tells you whether the voice terminal has Dial Access to the pool that con-
tains this line. Each successive touch of a line button gives you one of
the following codes:
Green light on = voice terminal has Dial Access to this pool
Green light off = voice terminal does not have Dial Access
Keep in mind that the lines in a pool always change as a group. Touching
any button representing a line in a pool affects all the lines in that pool.
7. Repeat steps 3 through 6 for each voice terminal whose Dial Access
to Line Pools you want to change.
if you want to give a different voice terminal the same Dial Access to
Line Pools as a voice terminal that has already been set up, use the
shortcut described below.
NOTE: When you copy the Dial Access assignments, you also copy ail
call restrictions, allowed-list permissions, and line and pool assignments
from the original voice terminal.
Dial the intercom number or touch the Auto intercom button of the
new voice terminal.
Touch Copy.
Dial the intercom number or touch the Auto intercom button of the
original voice terminal.
8. Touch Adm Tel.
Lights next to the administration mode buttons flash again.
9. Continue to administer your system or leave administration mode by
following the boxed instructions on page 25.
for example) or touch the Auto Intercom
a line pool to an attendant's
to this pool
the green
wait until
39